Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I have cropped views in my Inventor idw and now the view identifier is not available to label the view. Is there any reason why this happens and some way to bring the view identifier back ? I am using IV 2013 64-bit.
Also no that sometimes the Identifier itself may be in a total other location on the drawing. 90% of the times its in the center (mostly above) the cropped part.
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
Hi, thanks I am aware that the identifier can appear on the drawing in odd locations - it would still seem that when cropping a drawing view the identifier is not available and disappears, any suggestions would be appreciated. Thanks
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")