I have cropped views in my Inventor idw and now the view identifier is not available to label the view. Is there any reason why this happens and some way to bring the view identifier back ? I am using IV 2013 64-bit.
There's an icon which may be turned off. See image below:
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
___________________________Hi, thanks for your reply. I have already tried this however the identifier is still lost when cropping a view. Any suggestions would be appreciated.
Also no that sometimes the Identifier itself may be in a total other location on the drawing.
90% of the times its in the center (mostly above) the cropped part.
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
___________________________Hi, thanks I am aware that the identifier can appear on the drawing in odd locations - it would still seem that when cropping a drawing view the identifier is not available and disappears, any suggestions would be appreciated. Thanks