Inventor General Discussion

Inventor General Discussion

Reply
Active Member
acelove27
Posts: 8
Registered: ‎09-19-2012
Message 1 of 2 (198 Views)
Accepted Solution

Vertical Alignment of Points on Seperate Parallel Planes

198 Views, 1 Replies
09-21-2012 05:17 PM

Basically, I have two workplanes which are parallel to each other and offset by a certain distance. As illustrated in the picture below, I'd like to constrain points from each plane to have the same vertical alignment as those from the other plane (horizontal too, I suppose, but the horizontal dimension will be the same anyways).

 

VerticalAlignment.png

 

I'm not sure exactly how to accomplish this with a definitive constraint, so any help would be greatly appreciated.

*Expert Elite*
JDMather
Posts: 26,602
Registered: ‎04-20-2006
Message 2 of 2 (194 Views)

Re: Vertical Alignment of Points on Seperate Parallel Planes

09-21-2012 05:45 PM in reply to: acelove27

Project Geometry.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.