Community
Hellow everyone.
I need an advice on VBA.I want to create an assembly containning two non standard profile beams placed face to face.
How can I find the center of gravity axis for the two in order to allign them into the assembly?Is it possible or should I find an other way to try to allign them?
Hello DimitrisBalgis
To get the COG of component, you can do it like this (inspire by a piece of code from Bob Van der Donk) :
Scan you assembly to get the parts, set ocompocc as component occurence
Set odoc = oCompOcc.Definition.Document
Dim ocenterofmass As Point
If odoc.DocumentType = kPartDocumentObject Then
Set ocenterofmass = oCompOcc.MassProperties.CenterOfMass