Inventor General Discussion

Reply
Contributor
DimitrisBalgis
Posts: 15
Registered: ‎01-19-2012
Message 1 of 2 (79 Views)

VBA

79 Views, 1 Replies
04-21-2012 03:30 AM

Hellow everyone.

 

I need an advice on VBA.I want to create an assembly containning two non standard profile beams placed face to face.

How can I find the center of gravity axis for the two in order to allign them into the assembly?Is it possible or should I find an other way to try to allign them?

 

Product Support
pierre.masson
Posts: 227
Registered: ‎05-27-2010
Message 2 of 2 (48 Views)

Re: VBA

04-24-2012 12:20 AM in reply to: DimitrisBalgis

Hello DimitrisBalgis

 

To get the COG of component, you can do it like this (inspire by a piece of code from Bob Van der Donk) :

Scan you assembly to get the parts, set ocompocc as component occurence  

 

Set odoc = oCompOcc.Definition.Document

Dim ocenterofmass As Point

If odoc.DocumentType = kPartDocumentObject Then

Set ocenterofmass = oCompOcc.MassProperties.CenterOfMass

 

 

Pierre Masson Product Support Specialist PS MFG EMEA Autodesk, Inc.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.