Community
Hi!
I need help doing one simulation study.
I want to simulate what happens to, for example, an coke can when its subject to full vaccum inside.
So, what i normally would do its do apply yo the inner faces of the solid one pressure to the inside of +/- 0.1MPa (equivalent to almost full vaccu force [1kg/cm2]).
Until tis point its easy, my problem is what face do I select as fixed. Nothing is fixed when full vaccum is applied, the can is just standing on the table and it can compress in all directions. But if i don't select any face as fixed Inventor does no alow me to simulate.
any help on this?
Check this
Or just select the top face of the opening.
Can't find what you're looking for? Ask the community or share your knowledge.