Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
jleonard2500
Posts: 80
Registered: ‎04-14-2011
Message 1 of 1 (39 Views)

Using referenced geometry from a part in an assembly

39 Views, 0 Replies
04-30-2012 09:43 AM

I am new to using Inventor 2010(used solidworks previously), and I am trying to figure out how to dimension to or constrain assembly features to part features. Is this possible in Inventor? Inventor does not seem to allow it at least in the default configuration.

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.