Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
jleonard2500
Posts: 80
Registered: ‎04-14-2011
Message 1 of 1 (41 Views)

Using referenced geometry from a part in an assembly

41 Views, 0 Replies
04-30-2012 09:43 AM

I am new to using Inventor 2010(used solidworks previously), and I am trying to figure out how to dimension to or constrain assembly features to part features. Is this possible in Inventor? Inventor does not seem to allow it at least in the default configuration.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.