Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
Namoi1
Posts: 46
Registered: ‎08-27-2013
Message 11 of 11 (65 Views)

Re: Using parameter in Iproperties

01-07-2014 03:36 PM in reply to: ccarreiras

I think just right clicking on the exported parameter and choosing custom property format, and removing the check mark beside Units String would have been much simpler than Ilogic, but hey, up to you.

using IV2015
C-H
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.