Inventor General Discussion

Inventor General Discussion

Reply
Active Member
bcadenza
Posts: 9
Registered: ‎03-26-2006
Message 1 of 3 (903 Views)

Using inventor for woodworking, can I start top down?

903 Views, 2 Replies
10-12-2012 12:07 PM

I have read the tutorials on http://cadsetterout.com/ as they seem the only ones on this topic, and am leaning towards using the top-down method, but would like to start at an even higher level wher you only come up with the big picture first then figure out how to build it with parts.  For example lets say if you want to make a wooden enclosure, you make the outside of the part using a large solid by extruding and such, then somehow go from that to a box made up of 1/2" thick plywood, etc.  Does this method make any sense, how does anyone else make something wooden in inventor?

Thanks,

Bob

*Expert Elite*
Cadmanto
Posts: 3,320
Registered: ‎12-07-2011
Message 2 of 3 (897 Views)

Re: Using inventor for woodworking, can I start top down?

10-12-2012 12:20 PM in reply to: bcadenza

Bob,

It can be done.  Can be tedious, but you need to think things through carefully.

Take a look at these series of videos.

http://www.youtube.com/playlist?list=PL992BCE4AB35AD129

Best Regards,
Scott McFadden
Inventor Professional 2014
(Colossians 3:23-25)

Mentor
MisterZS
Posts: 164
Registered: ‎08-24-2012
Message 3 of 3 (823 Views)

Re: Using inventor for woodworking, can I start top down?

10-17-2012 03:51 AM in reply to: bcadenza

Hi,

yes you can and it is realy nice. I do woodworking with Inventor for few years and lot to learn and lot of fun.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.