Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Unable to apply coincident constraint with splines and projected points

1 REPLY 1
Reply
Message 1 of 2
Justin_DeSilva
230 Views, 1 Reply

Unable to apply coincident constraint with splines and projected points

I'm unable to apply coincident constraints to spline points with projected points as reference. 5 out of the 7 points were successful. Is there a reason I'm not able to apply coincident constraint to the remaining 2?

 

Steps involved..

 

1. Projected spline and points from earlier sketch (sometimes I keep a backup of the orignial spline for reference)

2. Selected spline and selected break link (I'm breaking the link so I can split the spline into 2 segments, allowing me to use the spline segments as guide rails when creating a loft)

3. Applied coincident contraint to points but 2 points create an error

1 REPLY 1
Message 2 of 2
chrisjuk12
in reply to: Justin_DeSilva

Hi Jusin,

 

Right click on the spline and select show degrees of freedom. Do you get allowable movement on the 2 points that you cannot constrain?

 

Can you upload the file so I can take a look?

 

Regards,

 

Chris

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report