Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
scottheide
Posts: 32
Registered: ‎01-17-2012
Message 1 of 4 (1,442 Views)
Accepted Solution

Turn off hatching

1442 Views, 3 Replies
12-04-2012 09:31 PM

We are using section views in our drawings.  However, we don’t want any hatching to show up.   I’ve scoured the hatch libraries and hatch documentation and I have not been able to figure out how to turn hatching off, or alternatively to create a hatch style that is blank.   My attempt at creating a blank hatching file is attached, but it didn’t work.

 

How can I turn off hatching or create a 'blank' .pat?

 

Any help would be greatly appreciated!

ScottHeide@CruzBayCustom.com

I think the easiest way is to switch off the hatch layer visibiltiy.

If you never want it switch it off in your template.

 

SWITCH OFF LAYER.png

*Expert Elite*
blair
Posts: 4,436
Registered: ‎11-13-2006
Message 2 of 4 (1,441 Views)

Re: Turn off hatching

12-04-2012 09:36 PM in reply to: scottheide

Can you select the hatch in the IDW and RMB on it and turn the visibility off

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 344.75
SpacePilot Pro 10.2.0 / 17.2.0.11011 / 4.17
Delta Tau Chi ΔΤΧ
*Expert Elite*
harco
Posts: 879
Registered: ‎02-16-2006
Message 3 of 4 (1,425 Views)

Re: Turn off hatching

12-05-2012 04:31 AM in reply to: scottheide

I think the easiest way is to switch off the hatch layer visibiltiy.

If you never want it switch it off in your template.

 

SWITCH OFF LAYER.png

Valued Contributor
EScales
Posts: 74
Registered: ‎05-01-2007
Message 4 of 4 (1,408 Views)

Re: Turn off hatching

12-05-2012 07:48 AM in reply to: scottheide

You can also turn off the hatching for an entire view, without turning off the hatch layer or right-clicking and hiding the hatch individually.

 

Hatch_Visibilty.PNG

Eric

Please select "Accept as Solution" if this answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2013 Certified Professional
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.