Inventor General Discussion

Inventor General Discussion

Reply
Valued Mentor
Lancasterm
Posts: 407
Registered: ‎05-07-2007
Message 1 of 2 (112 Views)

Tube & Pipe Style

112 Views, 1 Replies
09-16-2009 11:01 AM
I'm creating a tube & pipe style based on a custom pipe and elbow that was published to the CC. I am able to define the pipe and the correct ND and schedule information appears in the styles dialog box. However when I go to select the elbow from the list, it will not expand and unable to define the elbow. I have run across this problem before and I thought I had discovered what caused it. But guess not..

I am able to select any other custom elbow done in the same manner as this elbow and put it in the style.

There is no filter set and the connection size between the pipe and elbow matches.

Using INV 2008 PRO W/SP3 Edited by: Lancasterm on Sep 16, 2009 2:02 PM
Employee
ruth-chunhua.hu
Posts: 115
Registered: ‎04-06-2008
Message 2 of 2 (112 Views)

Re: Tube & Pipe Style

09-16-2009 07:42 PM in reply to: Lancasterm
Hello Lancasterm,

What standards did you author pipe and elbow as? If you need metric, please add M in the front of ND while authoring them. If your issue is not related with standard, do you mind to posy your custom pipe and elbow here? Or send them to me directly. My email is Ruth-chunhuaDOThu@autodeskDOTcom.


Thanks,
Ruth
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.