Inventor General Discussion

Posts: 3
Registered: ‎10-10-2012
Message 1 of 1 (163 Views)

Tube and Pipe tool

163 Views, 0 Replies
10-10-2012 11:03 PM

We are trying to use Tube and pipe tool to route piping with flanges. While doing so, we are not able to group them together so as to make one assembly to produce fabrication drawings.


Looking for solution.



Naim Shaikh

Naim Shaikh
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.