Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
naresh_kalyan
Posts: 157
Registered: ‎03-22-2006
Message 1 of 3 (149 Views)

Tube & Pipe in iAssembly

149 Views, 2 Replies
08-07-2012 06:38 PM

Hi all,

I need to create multiple tubes with various routes using "Pipe & Tube"  in iAssembly. Tubes need to be suppressed or unsuppressed in iFactory table as per the requirement.

 

When I started creating Tubes using "Tube & Pipe", it is creating subassemblies automatically. I can able to create multiple routes. But when tube & pipe is unsuppressed, all the tubes are getting unsuppressed.

Wheras I need to compute some  tubes and suppress some.

 

Is that possible with IN2012? If yes, anyone's help will be appreciated.

Thanks in advance.

 

NKalyan

Distinguished Contributor
naresh_kalyan
Posts: 157
Registered: ‎03-22-2006
Message 2 of 3 (114 Views)

Re: Tube & Pipe in iAssembly

08-13-2012 03:23 AM in reply to: naresh_kalyan

Hi again..

I have tried with mutliple methods in creation of iAssembly including Flexible Pipes. But, after conversion of Flexible pipe assembly into iAssembly, its adaptivity is going off. so that, the pipes are not exhibiting the flexiblility. Due to this reason, I could not able to drag the Flexible hoses...

 

All I need is to create an iAssembly with Flexible hose tubes. is this possible? Please, let me know.

 

Any suggestions will be enormously helpful. Thanks in advance.

 

Regards

NKalyan

Distinguished Contributor
naresh_kalyan
Posts: 157
Registered: ‎03-22-2006
Message 3 of 3 (90 Views)

Re: Tube & Pipe in iAssembly

09-02-2012 09:24 AM in reply to: naresh_kalyan

Hi again...

I'm still facing the same issue...

Whenever I'm making the Tubes as "Make adaptive", I got a prompt  "Make adaptive failled". This is the same problem I'm facing since a month.

 

Also, the same thing is furnished in Help.

 

Brian: Could you please clarify me....

 

Regards

NKalyan

 

 

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.