Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
jimmantle
Posts: 81
Registered: ‎12-28-2004
Message 1 of 1 (147 Views)

trouble with involute spline generator

147 Views, 0 Replies
09-16-2009 11:12 AM
I am trying to generate an internal involute spline in a blind bore and Inventor ignores the length of the spline requested. The bore has a counterbore larger than the major diameter of the spline at the bottom of the hole.
The length of the surface for the spline is 2 3/4", the preview shows a spline about 10" long, regardless of what I enter the length at and when I hit create, it gives an error message "this groove cannot be created".
Ideas?

Jim Mantle
Inv 2010 pro sp1, xp64
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.