Inventor General Discussion

Reply
Active Member
Ibanezmike
Posts: 7
Registered: ‎01-29-2014
Message 1 of 3 (228 Views)
Accepted Solution

Trim Problems

228 Views, 2 Replies
01-29-2014 02:44 AM

Hey guys, having some problems with the trim feature here. I am building a frame with the frame generator and would like to trim a short frame member that sits between 2 long parrallel members. When I choose trim to frame, the longer bar cuts its length to butt up against the short one. Trim/extend wont work at all, the ok button is greyed out. Frame.png

I have just found the answer, I was mis using the extend feature. Thanks for the quick reply.

*Expert Elite*
JDMather
Posts: 26,844
Registered: ‎04-20-2006
Message 2 of 3 (214 Views)

Re: Trim Problems

01-29-2014 03:53 AM in reply to: Ibanezmike

Attach the assembly here (only need the two parts and skeleton). 

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Active Member
Ibanezmike
Posts: 7
Registered: ‎01-29-2014
Message 3 of 3 (211 Views)

Re: Trim Problems

01-29-2014 03:56 AM in reply to: JDMather

I have just found the answer, I was mis using the extend feature. Thanks for the quick reply.

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.