Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
This isn't a big problem, but these two trails don't align. The nut and lock washer were pulled out of IV Library, oh maybe back in R7 or R8. When I explode them, the trails don't line up. They should though, shouldn't they?? An insert constraint was used on it.
Does in Calculate where to put the trail by the center of gravity? Is that why it is off to the one side, because of the cutout??
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")