Hi,
I am considering moving from SWX to IV and have just started my 30 day trial. Around 50% of my work will be plastic injection mould design.
I have got to the point of selecting the mold base and i only have DME or Futaba vendors listed however when the reseller demo'd this software there were far more vendors for instance Meusburger, Strack, Hasco etc. is there anyway to get these vendors activated within the software?
Any help greatly appreciated as i was planning on driving the software as much as possible over the next 3 days but the reseller is unfortunately closed for the next 3 days.
Regards
Tony
In addition to the built-in tutorials, check out the Vacuum tutorial in my signature.