Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Hello, I'm a MDT 6 user and I was just wondering if Inventor had means to perform tolerance analysis on an assembly. The MDT way to do this is very cumbersome so I was looking at new software but will use inventor if it can do the job.
If you mean setting dimensions at maximum or minimum tolerance, IV can do
it.
Rui
"jstraitiff" wrote in message
news:f19c292.-1@WebX.maYIadrTaRb...
> Hello, I'm a MDT 6 user and I was just wondering if Inventor had means to
perform tolerance analysis on an assembly. The MDT way to do this is very
cumbersome so I was looking at new software but will use inventor if it can
do the job.
>
