Inventor General Discussion

Reply
Valued Contributor
jstraitiff
Posts: 68
Registered: ‎11-12-2003
Message 1 of 4 (293 Views)

tolerance analysis

293 Views, 3 Replies
11-12-2003 01:20 AM
Hello, I'm a MDT 6 user and I was just wondering if Inventor had means to perform tolerance analysis on an assembly. The MDT way to do this is very cumbersome so I was looking at new software but will use inventor if it can do the job.
*RuiF
Message 2 of 4 (293 Views)

Re: tolerance analysis

11-12-2003 04:09 AM in reply to: jstraitiff
If you mean setting dimensions at maximum or minimum tolerance, IV can do
it.

Rui


"jstraitiff" wrote in message
news:f19c292.-1@WebX.maYIadrTaRb...
> Hello, I'm a MDT 6 user and I was just wondering if Inventor had means to
perform tolerance analysis on an assembly. The MDT way to do this is very
cumbersome so I was looking at new software but will use inventor if it can
do the job.
>
New Member
kdwynn
Posts: 1
Registered: ‎10-23-2012
Message 3 of 4 (169 Views)

Re: tolerance analysis

10-23-2012 07:20 AM in reply to: jstraitiff

Is there any ability to do a tolerance analysis with GD&T?

Distinguished Contributor
Ryan.Martinez
Posts: 141
Registered: ‎07-29-2011
Message 4 of 4 (162 Views)

Re: tolerance analysis

10-23-2012 07:27 AM in reply to: kdwynn

Not that I know of. That would be a pretty cool and useful feature to have.

 

You  can set tolerances to min/max/median/nominal and then check for interferance in the assembly environment.

 

PDS 2014
PDS 2015
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!