Inventor General Discussion

Reply
*Allen, Albert
Message 1 of 1 (47 Views)

To Rich Willis

47 Views, 0 Replies
12-06-2002 01:27 AM
I tried to e mail you with a question about your request to post some
problem assemblies and got this response:
"Please post your messages or replies directly in the newsgroups. Messages
are not accepted at this email address.

Thank you.

Autodesk Discussion Group Manager"

I would like to try and help but it looks like things are setup so I can't.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.