Inventor General Discussion

Inventor General Discussion

Reply
New Member
SrinathSibi
Posts: 1
Registered: ‎03-23-2012
Message 1 of 3 (759 Views)

To be able to twist and sweep a profile along a spline

759 Views, 2 Replies
05-14-2012 01:29 AM

Hello,

 

                     I am quite new to the inventor society and am stuck on a problem. My task is to model a twisted rope and for that i need to twist and sweep a certain profile ( please see attached jpg for a rough idea of the profile ) at the same time along a spline path. Inventor is unable to accept the spline path as axis for a coil feature. 

                      One possible solution was to use sweep with a guide rail , and for the guide rail we would have to use a helix wrapped around said spline. 

                       Can anyone suggest a method to either simultaneously sweep and twist a profile, or to be able to wrap a helix around a spline in inventor? I have attached a picture of the required helix too.

 

Thank you in advance for any replies,

Srinath

 

*Expert Elite*
JDMather
Posts: 26,877
Registered: ‎04-20-2006
Message 2 of 3 (747 Views)

Re: To be able to twist and sweep a profile along a spline

05-14-2012 03:26 AM in reply to: SrinathSibi

I would use a texture rather than actually model the twisted tri-lobe. 

By the time you back up a bit it will look the same.

Much easier and smaller file size.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
*Expert Elite*
PaulMunford
Posts: 917
Registered: ‎11-13-2006
Message 3 of 3 (711 Views)

Re: To be able to twist and sweep a profile along a spline

05-14-2012 05:55 AM in reply to: SrinathSibi

I don't think that you can helix around a spline in Inventor, I would be happy to hear from anyone who knows how!

 

For this model, how about patterning a workplane along the spline, and then using a sketch block for the profile. You will need to set the rotation of the sketch block manually in each case. Finally you can loft between the sketches to get your rope.

 

Let us know how you get on :smileyhappy:

 

Rope.png

The CAD Setter Out Blog @CadSetterOut

Inventor Surfacing | AutoCAD | CAD Standards
 
Please use the Mark Solutions! Accept as Solution or Give Kudos! Kudos functions - Thank you!
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.