Inventor General Discussion

Reply
Active Contributor
brandonherrer14
Posts: 27
Registered: ‎02-20-2012
Message 1 of 3 (268 Views)
Accepted Solution

Title Block Question

268 Views, 2 Replies
06-06-2012 03:26 PM

Dear Forum,

 

Really quick question...

 

When i make a drawing in inventor, in the Title Block, it says the title of the saved document in the Drawing No. section. So what i am saying is how do i get the title of the saved document out of the drawing number section and either delete it or get it in the Title section.

 

Thank You,

 

Brandon

 

P.S. There is a photo belowInventor tittle block problem snipping.JPG

Hi brandonherrer14,

 

It depends on how your title block is set up, but if you right-click on the top node in the browser of your drawing and choose iProperties, you can look on the Project tab for the Part Number field. If you see the offending text there, then just delete it and all should be well.

 

But if it's not there then you will want to open the model and right-click on the top node in the browser and choose iProperties. Then look on the Project tab for the Part Number field and remove remove/change the part number as needed.

 

Basically your title block reads information form the iProperties of either the drawing itself or the model that you place in the drawing.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com


*Expert Elite*
Curtis_Waguespack
Posts: 2,930
Registered: ‎03-08-2006
Message 2 of 3 (266 Views)

Re: Title Block Question

06-06-2012 03:36 PM in reply to: brandonherrer14

Hi brandonherrer14,

 

It depends on how your title block is set up, but if you right-click on the top node in the browser of your drawing and choose iProperties, you can look on the Project tab for the Part Number field. If you see the offending text there, then just delete it and all should be well.

 

But if it's not there then you will want to open the model and right-click on the top node in the browser and choose iProperties. Then look on the Project tab for the Part Number field and remove remove/change the part number as needed.

 

Basically your title block reads information form the iProperties of either the drawing itself or the model that you place in the drawing.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com




  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Active Contributor
brandonherrer14
Posts: 27
Registered: ‎02-20-2012
Message 3 of 3 (255 Views)

Re: Title Block Question

06-06-2012 05:43 PM in reply to: Curtis_Waguespack

Your great. Thank you for all your help.

 

Best of Luck,

 

Brandon

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.