Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
shmartin89
Posts: 74
Registered: ‎04-25-2012
Message 1 of 2 (262 Views)
Accepted Solution

Text Parameter- Equation value & Nominal Value

262 Views, 1 Replies
11-26-2012 05:31 AM

Is there any way in which the text of a text parameter, which is in the equation column, can be replicated into the nominal value column in the parameters table? I want to reference the value of the parameter in Custom iProperties but it always comes up as blank because it has no value.

 

I need it to update automatically, e.g not entering the value manually.

 

Cheers

Sandy

Hi Sandy

You can try iLogic to address your requirement, it's quite easy.

iProperties.Value("Custom", "Your Custom iProperty Name")=Text

Here,  Text stands for a text parameter in f(x) table.

 

Regards,

Employee
jingyi.liu
Posts: 121
Registered: ‎08-28-2007
Message 2 of 2 (230 Views)

Re: Text Parameter- Equation value & Nominal Value

11-27-2012 11:13 PM in reply to: shmartin89

Hi Sandy

You can try iLogic to address your requirement, it's quite easy.

iProperties.Value("Custom", "Your Custom iProperty Name")=Text

Here,  Text stands for a text parameter in f(x) table.

 

Regards,

Inventor Professional 2015

Jingyi Liu
Quality Assurance Team
Autodesk
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.