Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
paul_pearson
Posts: 35
Registered: ‎03-03-2013
Message 1 of 4 (152 Views)
Accepted Solution

text alignment

152 Views, 3 Replies
07-16-2013 04:02 AM

Hi

 

I have text in a circular shape but how do i place the text inside the part on to the front of the face?

 

Thanks

 

Paul

Inventor 2013

You could have used the inside arc rather than the outside arc.

In either case, enter the Offset Distance.  (edit the sketch and double click on text)

you could delete the constrain from the outer circle, making it normal geometry instead of projected, and then dimension the circle so it's on the inside.
*Expert Elite*
JDMather
Posts: 28,228
Registered: ‎04-20-2006
Message 2 of 4 (146 Views)

Re: text alignment

07-16-2013 04:14 AM in reply to: paul_pearson

You could have used the inside arc rather than the outside arc.

In either case, enter the Offset Distance.  (edit the sketch and double click on text)

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
*Expert Elite*
-niels-
Posts: 1,627
Registered: ‎06-20-2006
Message 3 of 4 (141 Views)

Re: text alignment

07-16-2013 04:18 AM in reply to: paul_pearson
you could delete the constrain from the outer circle, making it normal geometry instead of projected, and then dimension the circle so it's on the inside.

Using IV2014 Pro SP2 - upd.1, Win7-64bit
Active Contributor
paul_pearson
Posts: 35
Registered: ‎03-03-2013
Message 4 of 4 (102 Views)

Re: text alignment

07-16-2013 09:03 PM in reply to: -niels-

Thank you

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.