Inventor General Discussion

Inventor General Discussion

Reply
Active Member
adavis
Posts: 8
Registered: ‎07-06-2011
Message 1 of 5 (453 Views)
Accepted Solution

Template

453 Views, 4 Replies
10-26-2012 08:29 AM

I have changed my template using the styles library.  For some reason Inventor 2013 will not let me save my new settings as a default in my newly created template.  Instead it gives me an error message that reads:

 

" The following style definitions in template ....... differ from the definitions in the style library; the style library will be used.

 

Part list:smileytongue:art list (ANSI), Revision Table: Revision Table (ANSI)

 

If the style definitions in the style library are intended for the new document, update the template with the new style definitions.  If the style definition in the template are intended for the new document, remove these styles from your style library using the Style Library Manager."

 

There must be an easy solution to my answer.  Do I need to change the name of my new styles so that the program will not get confused?   Hopefully you can help

 

Thanks

 

Right you are.

Distinguished Mentor
john.retzlaff
Posts: 947
Registered: ‎11-03-2003
Message 2 of 5 (435 Views)

Re: Template

10-26-2012 10:31 AM in reply to: adavis

Make sure you have Read/Write access to your sytes library.

Open the template that has the styles the way you want them.

Go to Manage tab, Styles and Standards panel and click Update.

 

That will push the styles that are different in your template back to the style library.

Next time you use the template, you should not see that message.

John Retzlaff
*Expert Elite*
mrattray
Posts: 2,536
Registered: ‎09-13-2011
Message 3 of 5 (426 Views)

Re: Template

10-26-2012 11:04 AM in reply to: john.retzlaff

I think you mean click "Save", not "Update".

Update will change the current file to match the library.

Save will change the library to match the current file.

Mike (not Matt) Rattray

Distinguished Mentor
john.retzlaff
Posts: 947
Registered: ‎11-03-2003
Message 4 of 5 (421 Views)

Re: Template

10-26-2012 11:37 AM in reply to: mrattray

Right you are.

John Retzlaff
Active Member
asvind
Posts: 6
Registered: ‎06-04-2012
Message 5 of 5 (320 Views)

Re: Template

11-21-2012 01:30 AM in reply to: adavis

How to check the in which template the part was created before?

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.