Telephone hand set cord

[koehler]

What is the best method to model a telephone handset cord?
Or... better yet does someone have one modeled already they would like to share?

[Anonymous]

Get a cordless!

koehler wrote:
> What is the best method to model a telephone handset cord?
> Or... better yet does someone have one modeled already they would like to share?

[koehler]

Very funny. Its not for a telepnone. Cord set is used for many applications.

[Anonymous]

Hi,

You can use the coil feature to create a telephone cord. You will need
to select a profile and an axis to create the coil around.

Thank you,
Tanya Garner
Inventor QA


wrote in message news:5201690@discussion.autodesk.com...
Very funny. Its not for a telepnone. Cord set is used for many
applications.

[koehler]

Thanks, I want to create the cord so it goes from point A to point B as it will lies naturally. Not straight as in the coil feature command. I'm guessing it would be 3d sweep.

[JDMather]

Have fun.
http://discussion.autodesk.com/thread.jspa?messageID=4915619
General idea of a method.
A little easier in r11, but I doubt it can be done. I tried to do something for a stapler spring recently without much success other than visual rep from a distance. (If you search here on the term stapler you might be able to find the dwf.) I would go for a texture that from just a little distance would look just fine.

[Anonymous]

Dear Mr. Mather,
As we all know that you're teaching the "other" soft, is it possible to do
this with the "other"?

Jake

[Anonymous]

Hi,
Could you take a look at the attached figure made by Cable and Harness
module in AIP?
You can find the sample files under your inventor installation path...\Cable
& Harness\Samples\Rackmount Enclosure\ if you have AIP installed.

Thanks.
-Oboe Wu
AIP QA

wrote in message news:5201850@discussion.autodesk.com...
Thanks, I want to create the cord so it goes from point A to point B as it
will lies naturally. Not straight as in the coil feature command. I'm
guessing it would be 3d sweep.

[Anonymous]

Here comes the part model. Just in case:)
Let me know if you have further requirements.

-Oboe Wu
AIP QA

"Oboe Wu (Autodesk)" wrote in message
news:5202269@discussion.autodesk.com...
Hi,
Could you take a look at the attached figure made by Cable and Harness
module in AIP?
You can find the sample files under your inventor installation path...\Cable
& Harness\Samples\Rackmount Enclosure\ if you have AIP installed.

Thanks.
-Oboe Wu
AIP QA

wrote in message news:5201850@discussion.autodesk.com...
Thanks, I want to create the cord so it goes from point A to point B as it
will lies naturally. Not straight as in the coil feature command. I'm
guessing
it would be 3d sweep.

[Anonymous]

15 minutes

[WDannels]

I am deaf and that is why I didn't answer that phone call. Try a different number.

Cheers,
Wendy