Inventor General Discussion

Reply
Active Member
lukerz
Posts: 6
Registered: ‎04-06-2010
Message 21 of 22 (141 Views)

Re: Tapped Hole Error

04-06-2010 05:16 AM in reply to: alcuratolo
I can understand your issue because I am experiencing the same thing at work. I then decided to check it out at home and both the tapped holes and thread functions performed fine. The only thing that I can think of is the OS. Most of you are running Windows XP where I am running on Vista... Edited by: lukerz on Apr 6, 2010 12:16 PM
Employee
shekarsub[Autodesk]
Posts: 229
Registered: ‎03-17-2004
Message 22 of 22 (141 Views)

Re: Tapped Hole Error

04-06-2010 06:22 AM in reply to: alcuratolo
I have attached the same document as Word 2003 format. Hope you can open this. Please try the steps in this doc and see if it helps or not. It would be great if you can report back if it worked or not.

Regards
shekar
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.