Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
sean_gtm
Posts: 77
Registered: ‎10-23-2003
Message 1 of 1 (41 Views)

Tapped hole conversion problem from MDT6

41 Views, 0 Replies
11-04-2002 05:23 PM
Hi.....I'm designing a new machine which has a few legacy parts from MDT6 (originally MDT5).....I've noticed a problem when converting MDT6 parts which have tapped holes....The part translates fine, but initially there is no standard specified in the hole dialog box.....To correct this you can simply select the standard you need - but it's a bit of a pain to select every tapped hole in every convered part.......A picture is worth a 1000 words, so see the file in the CF.....Unzip it, open it and create an idw........Then try to spot the thread lines on the 3 tapped holes........Cheers.....Sean
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!