Inventor General Discussion

Reply
*Chasek, Jerry
Message 1 of 2 (45 Views)

Sweeping Tubing

45 Views, 1 Replies
11-04-2002 10:40 PM
Good morning fellow IV6 users. I am wondering if it is possible to create a
10 ft length of a standard shape out of the library such as ASTM 2" OD round
tubing and then apply a sweep command to bend this shape and still keep it
10 ft long?

Jerry Chasek
Minden Machine Shop Inc.
*Bliss, Charles
Message 2 of 2 (45 Views)

Re: Sweeping Tubing

11-04-2002 11:46 PM in reply to: *Chasek, Jerry
No, but you could create a sweep profile using formulas with reference
dimensions which drive driven dimensions or vise-versa.

Jerry Chasek wrote:
> Good morning fellow IV6 users. I am wondering if it is possible to create a
> 10 ft length of a standard shape out of the library such as ASTM 2" OD round
> tubing and then apply a sweep command to bend this shape and still keep it
> 10 ft long?
>
> Jerry Chasek
> Minden Machine Shop Inc.
>
>
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.