Inventor General Discussion

Reply
Distinguished Contributor
cadcamm99
Posts: 157
Registered: ‎04-12-2005
Message 1 of 2 (225 Views)

Sweep with Guide Rail

225 Views, 1 Replies
11-06-2012 11:58 AM

 am using Inventor 2012.  Is there any way to select two rails when sweeping? One for the x and one for the y.  I can only select one rail. If I choose Profile Scaling X & Y, it does not sweep the way I want to.

*Expert Elite*
JDMather
Posts: 27,044
Registered: ‎04-20-2006
Message 2 of 2 (221 Views)

Re: Sweep with Guide Rail

11-06-2012 12:06 PM in reply to: cadcamm99

Can you attach the file here?

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.