Inventor General Discussion

Inventor General Discussion

Reply
Active Member
OOBean
Posts: 7
Registered: ‎09-13-2013
Message 1 of 4 (346 Views)
Accepted Solution

Sweep - Trimming and discarding faces error!!

346 Views, 3 Replies
09-26-2013 04:29 AM

Hi all,

 

I'm trying to sweep six circles along 6 3d sketches however I recieve the 'The attempted operation had problems trimming and discarding faces. Try again with different outputs.

 

I have been suffering with the above error message and i am at my wits end. I've tried tracing the the geometry, played dot to dot joining up the points but to no avail. Some sweeps work and others dont.

 

Any help would be greatly appreciated

 

Thanks

Hi!

 

 

In Sweep tool, if you change to parallel it works!

 

1.png

 

 

Did you find this reply helpful ? If so, use the  Mark Solutions!  Accept as Solution or Give Kudos!Kudos - Thank you!

Distinguished Mentor
ccarreiras
Posts: 973
Registered: ‎02-04-2010
Message 2 of 4 (335 Views)

Re: Sweep - Trimming and discarding faces error!!

09-26-2013 05:16 AM in reply to: OOBean

Hi!

 

 

In Sweep tool, if you change to parallel it works!

 

1.png

 

 

Did you find this reply helpful ? If so, use the  Mark Solutions!  Accept as Solution or Give Kudos!Kudos - Thank you!

Regards.
CarlosC

Autodesk Inventor 2014 Certified Professional
Autodesk Factory Design Suite Ultimate 2015
Windows 7 64Bit
Active Member
OOBean
Posts: 7
Registered: ‎09-13-2013
Message 3 of 4 (328 Views)

Re: Sweep - Trimming and discarding faces error!!

09-26-2013 05:20 AM in reply to: ccarreiras

Thanks very much Carlos

Employee
GlennChun
Posts: 115
Registered: ‎06-10-2004
Message 4 of 4 (298 Views)

Re: Sweep - Trimming and discarding faces error!!

09-26-2013 01:33 PM in reply to: OOBean

Hello OOBean,

 

Thanks for reporting this issue.  We have logged DID 1506198 in our database.

 

Glenn

Autodesk, Inc.

 

Autodesk T-Splines Component Development
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.