Inventor General Discussion

Inventor General Discussion

Reply
Active Member
blburson
Posts: 6
Registered: ‎07-17-2009
Message 1 of 3 (194 Views)
Accepted Solution

Sweep or create 3d project to surface?

194 Views, 2 Replies
11-29-2012 08:35 AM

Hello users,

I'm racking my brain try to figure out how to do this. Picture this, a tubular feature that has a path that runs along the circumference and turns linnear. A path thats .3125 in diameter. I attached a file that shows a hand sketch with this post but I can't tell if it  will show up. If anyone can offer help, it would be greatly appreciated. thank you.

3D sketch - wrap to face

Sweep with guide surface.

*Expert Elite*
JDMather
Posts: 27,471
Registered: ‎04-20-2006
Message 2 of 3 (183 Views)

Re: Sweep or create 3d project to surface?

11-29-2012 09:07 AM in reply to: blburson

3D sketch - wrap to face

Sweep with guide surface.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Active Member
blburson
Posts: 6
Registered: ‎07-17-2009
Message 3 of 3 (173 Views)

Re: Sweep or create 3d project to surface?

11-29-2012 12:07 PM in reply to: JDMather

Awesome, it worked!  Thank you so much.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.