Inventor General Discussion

Inventor General Discussion

Reply
Active Member
blburson
Posts: 6
Registered: ‎07-17-2009
Message 1 of 3 (190 Views)
Accepted Solution

Sweep or create 3d project to surface?

190 Views, 2 Replies
11-29-2012 08:35 AM

Hello users,

I'm racking my brain try to figure out how to do this. Picture this, a tubular feature that has a path that runs along the circumference and turns linnear. A path thats .3125 in diameter. I attached a file that shows a hand sketch with this post but I can't tell if it  will show up. If anyone can offer help, it would be greatly appreciated. thank you.

3D sketch - wrap to face

Sweep with guide surface.

*Expert Elite*
JDMather
Posts: 26,900
Registered: ‎04-20-2006
Message 2 of 3 (179 Views)

Re: Sweep or create 3d project to surface?

11-29-2012 09:07 AM in reply to: blburson

3D sketch - wrap to face

Sweep with guide surface.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Active Member
blburson
Posts: 6
Registered: ‎07-17-2009
Message 3 of 3 (169 Views)

Re: Sweep or create 3d project to surface?

11-29-2012 12:07 PM in reply to: JDMather

Awesome, it worked!  Thank you so much.

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.