Hekko,
I have a part I'd like to remove a portion of a surface from, but I'm doing something wrong and I can't figure it out. I've been working on it for a while now. From what I can see, the geometry for the cut is correct, I just can't seem to get it to cut out:
The three sketches that define thearea to be removed are highlighted in the above screen capture.
Attached is the part in question.
If you have a solution, a brief description on what you did will be more helpful, for future use, than just completing the cut and shipping the part back to me... though I will not turn that down!
Thank you.
Solved! Go to Solution.
Solved by JDMather. Go to Solution.
Solved by JDMather. Go to Solution.
Is something like this what you are after?
Here are a couple of more robust techniques for modeling the part.
There is a subtle difference between the two.
2 very simple sketches - no extra workplanes