Inventor General Discussion

Inventor General Discussion

Reply
Member
1humanash
Posts: 4
Registered: ‎04-12-2012
Message 1 of 1 (42 Views)

Suppressed components matrix??

42 Views, 0 Replies
04-12-2012 09:55 PM

I have an I iAssembly that contains a base part and then 16 other parts that are split into 2 groups (left side=8 ,right side=8). I would like to use a form with a drop down selection box to chose the desired component for the left side and then another form to chose the right side. When the desired component is selected I then want all other parts on that side to be suppressed.

I could create a matrix in the iAssembly table and make a line for each combination which had the correct parts included or excluded but I have no idea how I would then drive this from a user friendly form.

Is it possible to switch between IAssembly configurations using forms/rules?

 

Any hints, suggestions,code would be much appreciated

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.