Inventor General Discussion

Inventor General Discussion

Reply
Mentor
j.vanderheijden
Posts: 237
Registered: ‎06-13-2011
Message 1 of 2 (140 Views)

suppress flanges

140 Views, 1 Replies
11-15-2012 01:18 PM

I am trying to make a way that suppress the flange features of all the panels that will be insert in the assy so i can suppress al the features at ones in a assy and don't have to do that for each panel separately.

I have a assy with parameters and i have a part with no geometry but have linked the parameters from the assy.

In my panel part i link the parameters to the part with no geometry.

When i use the parameter in the assy to suppress the flanges that works the way i want it.

But when i insert the panel part into that assy it dus't work.

I think i miss a link, can anybody help me out?

Mvg Jos

Your drawings are only as good as the symbols that complete them...
Mentor
j.vanderheijden
Posts: 237
Registered: ‎06-13-2011
Message 2 of 2 (124 Views)

Re: suppress flanges

11-20-2012 12:41 PM in reply to: j.vanderheijden

I am now ready to succeed to suppress the flanges off the parts in my assy.
The problem now is that if I place a panel with 'Place' it goes well even if I use a different type of panel.
But if I place the panel on "Place iLogic Component" then it does not work.
The panel is the same as when I was with 'Place' insert.
Everything is linked to the same parameters and the same part,  the part 'Koppeling'.

Can somebody help me out.

Mvg Jos

Your drawings are only as good as the symbols that complete them...
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.