Inventor General Discussion

Reply
Member
mcnaul
Posts: 3
Registered: ‎05-28-2010
Message 1 of 1 (91 Views)

Stress Analysis

91 Views, 0 Replies
11-27-2012 06:01 AM

Good Afternoon,

 

I am trying to carry out a stress analysis on a new design which involves a ball and socket feature. I want to test the force it takes to pull the ball free of the socket as this is key to the design.

 

Unfortunately I cannot post an image of the design as it is still under research and development but any help would be greatly appreciated. I am running Inventor 2013.

 

 

Kind Regards,

Kathryn McNaul

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.