Inventor General Discussion

Inventor General Discussion

Reply
Active Member
best_industry
Posts: 7
Registered: ‎11-28-2012
Message 1 of 4 (190 Views)
Accepted Solution

Stress Analysis

190 Views, 3 Replies
01-30-2013 12:45 AM

Hi!

 

I'm currently doing a project and it involves the use of a flat rectangular plate/beam. Dimension approximately about 100mm by 10mm by 2mm. A constant load will be applied on the end of the surface. I would like to find out if there is a way to find out the maximum number of times i can apply the load (after applying the load, it will be removed and applied on the same point again) to the beam until it fails? I would also like to know if i can apply mulitple loads, at different internal and achieve this too?

 

Thank you!

*Expert Elite*
JDMather
Posts: 26,585
Registered: ‎04-20-2006
Message 2 of 4 (170 Views)

Re: Stress Analysis

01-30-2013 04:09 AM in reply to: best_industry

You will need some othe product - perhaps Autodesk Simulation.
You cannot do this analysis in Autodesk Inventor.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Active Member
best_industry
Posts: 7
Registered: ‎11-28-2012
Message 3 of 4 (147 Views)

Re: Stress Analysis

01-30-2013 10:47 AM in reply to: JDMather

Thank you for the response JDMather

 

Which simulation software will allow me to find out fatigue failure? Autodesk Simulation 360 or Autodesk Simulation Multiphysics?

*Expert Elite*
JDMather
Posts: 26,585
Registered: ‎04-20-2006
Message 4 of 4 (142 Views)

Re: Stress Analysis

01-30-2013 11:15 AM in reply to: best_industry

You should probably post your question over here

http://forums.autodesk.com/t5/Autodesk-Simulation-Mechanical/bd-p/396

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.