Inventor General Discussion

Reply
Active Member
best_industry
Posts: 7
Registered: ‎11-28-2012
Message 1 of 4 (193 Views)
Accepted Solution

Stress Analysis

193 Views, 3 Replies
01-30-2013 12:45 AM

Hi!

 

I'm currently doing a project and it involves the use of a flat rectangular plate/beam. Dimension approximately about 100mm by 10mm by 2mm. A constant load will be applied on the end of the surface. I would like to find out if there is a way to find out the maximum number of times i can apply the load (after applying the load, it will be removed and applied on the same point again) to the beam until it fails? I would also like to know if i can apply mulitple loads, at different internal and achieve this too?

 

Thank you!

You will need some othe product - perhaps Autodesk Simulation.
You cannot do this analysis in Autodesk Inventor.

*Expert Elite*
JDMather
Posts: 27,983
Registered: ‎04-20-2006
Message 2 of 4 (173 Views)

Re: Stress Analysis

01-30-2013 04:09 AM in reply to: best_industry

You will need some othe product - perhaps Autodesk Simulation.
You cannot do this analysis in Autodesk Inventor.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Active Member
best_industry
Posts: 7
Registered: ‎11-28-2012
Message 3 of 4 (150 Views)

Re: Stress Analysis

01-30-2013 10:47 AM in reply to: JDMather

Thank you for the response JDMather

 

Which simulation software will allow me to find out fatigue failure? Autodesk Simulation 360 or Autodesk Simulation Multiphysics?

*Expert Elite*
JDMather
Posts: 27,983
Registered: ‎04-20-2006
Message 4 of 4 (145 Views)

Re: Stress Analysis

01-30-2013 11:15 AM in reply to: best_industry

You should probably post your question over here

http://forums.autodesk.com/t5/Autodesk-Simulation-Mechanical/bd-p/396

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!