Inventor General Discussion

Posts: 1,958
Registered: ‎05-18-2011
Message 11 of 11 (106 Views)

Re: Spiral Flat Pattern

12-13-2012 04:31 AM in reply to: aarmacost

I have use SPI sheet metal software before and works great. And I do know it will do Strakes for stacks.


A strake is a spiral sheet metal used to help tall stacks.

Please mark this response as "Accept as Solution" if it answers your question.

James Letcher
2012 Factory Design Suite ( will not load 2013)
What happen to my Inventor :-(
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.