Inventor General Discussion

Reply
Member
lester86_1
Posts: 5
Registered: ‎09-07-2011
Message 1 of 3 (141 Views)

sliding pin

141 Views, 2 Replies
09-30-2011 04:08 AM

how do I constrain a pin with in a slot allowing the pin to move freely within the slot?

*Expert Elite*
MariaManuela
Posts: 870
Registered: ‎12-04-2003
Message 2 of 3 (139 Views)

Re: sliding pin

09-30-2011 04:26 AM in reply to: lester86_1

Hi

Try the Transition Constraint.

 

 

Transitional.png

Maria Manuela Pinho
Application Specialist
Cadtech / Asidek - Autodesk Gold Partner
Autodesk Inventor Professional 2015 | Lenovo W520
*Expert Elite*
JDMather
Posts: 27,509
Registered: ‎04-20-2006
Message 3 of 3 (133 Views)

Re: sliding pin

09-30-2011 04:59 AM in reply to: lester86_1

There are several ways to do this - attach your assembly here if you can't figure it out.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.