Inventor General Discussion

Inventor General Discussion

Reply
New Member
antonyandraws
Posts: 2
Registered: ‎11-18-2012
Message 1 of 3 (357 Views)
Accepted Solution

Slice view of bearing assembly

357 Views, 2 Replies
11-25-2012 11:52 AM

I have an assembly which contains some content centre tapered roller bearings. When I do a slice of the entire assembly the bearings remain solid. Within the document settings>modelling tab the "Participate in Assembly and Drawing sections" is checked.

 

How can I get the part to be sliced within the half sliced view like everything else?

 

Thank you.

*Pro
sbixler
Posts: 1,925
Registered: ‎09-15-2003
Message 2 of 3 (340 Views)

Re: Slice view of bearing assembly

11-25-2012 04:46 PM in reply to: antonyandraws
New Member
antonyandraws
Posts: 2
Registered: ‎11-18-2012
Message 3 of 3 (335 Views)

Re: Slice view of bearing assembly

11-25-2012 04:53 PM in reply to: sbixler

Thank you so much! I'm sure you get these annoying repeats of questions very often. Thanks for enduring.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.