Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Hi again 🙂 I'm trying to do a sketch in drawing view (done that) but I also
wanna constrain the sketched line to the model's visible edge. How do i do
this?
In IV6, you have to manually project view entities into the sketch, and you
have to finish the command by RMB/Done.
I've had some troubles doing this sience the new SP2, though (but might stem
from my lack of skill).
Regards,
--
Leo Laimer
Maschinen- und Fertigungstechnik
A-4820 Bad Ischl - Austria
"Leo Laimer" wrote in message
news:747D81069D35F5EA2BC14CFBEFDC9C54@in.WebX.maYIadrTaRb...
> In IV6, you have to manually project view entities into the sketch, and
you
> have to finish the command by RMB/Done.
> I've had some troubles doing this sience the new SP2, though (but might
stem
> from my lack of skill).
>
> Regards,
> --
> Leo Laimer
> Maschinen- und Fertigungstechnik
> A-4820 Bad Ischl - Austria
>
>
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")