Inventor General Discussion

Inventor General Discussion

Reply
*Brentner, Jack
Message 1 of 1 (56 Views)

Sketched Symbols scalable - follow view scale.

56 Views, 0 Replies
11-24-2002 06:04 AM
Now a sketch symbol is scalable (think dowel hole symbol) in IV6, and
various "attachment points" light up in an IDW view for accurate placement
and will follow a view.

But: Can they be placed "inside" the view, such that they will follow the
scale of the view? For example if I should determine that all the views at a
later date should be half scale instead of full scale, how do I get the
dowel hole symbols to scale down with the view?

I am aware of starting a sketch "within" the view and projecting the holes'
geometry, then drawing verticals, horizontals and finally hatch filling the
1st and 3rd quadrants. This approach is very slow and one-by-one, i.e.if a
platen has 20 dowel holes.



Many Thanks,
Jack
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.