Inventor General Discussion

Inventor General Discussion

Reply
Contributor
Fleagle8t
Posts: 22
Registered: ‎06-26-2012
Message 1 of 3 (391 Views)
Accepted Solution

Sketch text parameters inventor 2012

391 Views, 2 Replies
11-27-2012 02:15 PM

I have several name plates which are embossed, and only the description changes from job to job, but find it a nuisance having to go into the part,edit sketch then edit text! each time I want to change the description .

I was initially going to get round this by creating a form and linking it to the text parameter!  But for some reason it won't take in the text parameter I created and will only find and take in numerical parameters?

 Is there any way around this? Or am I doing something wrong?, I know it is possible in inventor 2013.

I am currently working with Inventor professional 2012 Any help would be greatly apprieciated.:smileyhappy:

 

 

Hi F leagle8t,

 

Mark Randa has written some ilogic to do help with this. You can find a link and an example file here:

http://forums.autodesk.com/t5/Autodesk-Inventor/Emboss-File-Name-on-Part/m-p/3288659#M422787

 

As you mentioned Inventor 2013 will do this without the need for iLogic.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com

*Expert Elite*
Curtis_Waguespack
Posts: 2,930
Registered: ‎03-08-2006
Message 2 of 3 (390 Views)

Re: Sketch text parameters inventor 2012

11-27-2012 02:21 PM in reply to: Fleagle8t

Hi F leagle8t,

 

Mark Randa has written some ilogic to do help with this. You can find a link and an example file here:

http://forums.autodesk.com/t5/Autodesk-Inventor/Emboss-File-Name-on-Part/m-p/3288659#M422787

 

As you mentioned Inventor 2013 will do this without the need for iLogic.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Contributor
Fleagle8t
Posts: 22
Registered: ‎06-26-2012
Message 3 of 3 (378 Views)

Re: Sketch text parameters inventor 2012

11-27-2012 03:03 PM in reply to: Fleagle8t
As always Curtis, you have the solution!
Many,Many thanks.

You're a Star.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.