Inventor General Discussion

Inventor General Discussion

Reply
*Conneally, Nick
Message 1 of 3 (32 Views)

sketch selection - creating features

32 Views, 2 Replies
11-08-2002 02:26 AM
I always seem to struggle with sketch selection when creating a feature;
i.e. simple extrusion with 2 circles, one on the face of a previous feature,
he other the existing sketched circle. I know you can de-select after both
are highlighted and selected.. is this the only way?. I am currently
attempting a loft going from a circle on the face of an existing octagon
feature to a larger circle .75" away. NO matter what I try, the octagon
portion is picked up as part of the loft (I only want the circle inside of
it).
*Hintehoeller, Richard
Message 2 of 3 (32 Views)

Re: sketch selection - creating features

11-08-2002 02:29 AM in reply to: *Conneally, Nick
Nick:

Is there anything preventing you from making the octagon out of
construction lines?

Richard

Nick Conneally wrote:
> I always seem to struggle with sketch selection when creating a feature;
> i.e. simple extrusion with 2 circles, one on the face of a previous feature,
> he other the existing sketched circle. I know you can de-select after both
> are highlighted and selected.. is this the only way?. I am currently
> attempting a loft going from a circle on the face of an existing octagon
> feature to a larger circle .75" away. NO matter what I try, the octagon
> portion is picked up as part of the loft (I only want the circle inside of
> it).
>
>
>
Distinguished Contributor
jiml
Posts: 387
Registered: ‎12-10-2003
Message 3 of 3 (32 Views)

Re: sketch selection - creating features

11-08-2002 03:13 AM in reply to: *Conneally, Nick
just delet one of the lines of the octagon
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.