Umm ... email ... where did you send it? You send it to my insightbb email
or to my houston.rr email? Guess I'll still be in KY for awhile they want me
to stay at least to the end of this project. They will'n to pay I'm will'n
to stay, I guess, so use the insightbb address as seen below with the X's.
~Larry
"Michael Puschner" wrote in message
news:5046238@discussion.autodesk.com...
No time warp, Larry.
We just live a few hours in the future here in Europe. *g*
BTW: Did you receive my email?
--
Michael
"Larry Caldwell" schrieb im Newsbeitrag
news:5046222@discussion.autodesk.com...
And I refreshed before posting ... was that a time warp!
~Larry
"Michael Puschner" wrote in message
news:5046210@discussion.autodesk.com...
Use the Project Geometry command to project the origin point into your
sketch. Than you can use this projected point for constraints and
dimensions.
--
Michael Puschner
www.scholle.de
schrieb im Newsbeitrag news:5046205@discussion.autodesk.com...
Actually, I want the Sketch Geometry, say a rectangle, to always be centered
on one or both planes perpendicular to the sketch plane. Then when I extrude
midplane, the solid is centered on the intersection of all the planes
(origin).
Coming from solidworks, it was possible to dimension to any plane in a
sketch, haven't seen that capability yet with inventor.