Inventor General Discussion

Inventor General Discussion

Reply
Member
rolabendan
Posts: 4
Registered: ‎05-07-2009
Message 1 of 3 (125 Views)

Sketch Geometry in idw Files

125 Views, 2 Replies
05-07-2009 04:04 AM
In reference to the following drawing notes procedure from Autodesk:

http://images.autodesk.com/emea_nw_w_main/files/multiple_drawing_notes.pdf

The Tip Box following Step 1 mentions the use of sketch geometry, This referenced geometry (construction lines?) is apparently not visible when the sketched symbols are inserted into a drawing. The Construction button and the Style pull-down box are not available in sketch mode within idw files. How are these referenced lines made invisible when the sketch symbols are inserted?

Note: The above procedure references Inventor 2008, I am currently using Inventor 2009, 32-Bit Edition, SP1.
Valued Mentor
pcunningham1
Posts: 1,195
Registered: ‎10-07-2003
Message 2 of 3 (125 Views)

Re: Sketch Geometry in idw Files

05-07-2009 05:01 AM in reply to: rolabendan
In the idw sketch environmment there is a a toggle button for 'sketch only', which is the equivalent to construction lines in parts.



-Paul Cunningham
Paul Cunningham
IV2008
Member
rolabendan
Posts: 4
Registered: ‎05-07-2009
Message 3 of 3 (125 Views)

Re: Sketch Geometry in idw Files

05-07-2009 05:16 AM in reply to: rolabendan
Ok. Problem solved. Thank you.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.